Sony AVD-S10 Operating Instructions Manual page 27

xLEVEL
You can vary the level of each speaker as follows. The default settings are underlined.
• C. LEVEL 0 dB (centre speaker level)
Adjust the level of the centre speaker (you can adjust from –10 dB to +10 dB in 1 dB steps).
• R. LEVEL 0 dB (rear speakers level)
Adjust the level of the rear speakers (you can adjust from –10 dB to +10 dB in 1 dB steps).
• SW. LEV. 0 dB (subwoofer level)
Adjust the level of the subwoofer (you can adjust from –10 dB to +10 dB in 1 dB steps).
Notes
• When you select an item, the sound cuts off for a moment.
• Depending on the settings of other speakers, the subwoofer may output excessive sound.
To adjust the volume of all the speakers at one time
Use the VOLUME control.
Other AMP MENU settings
You can control the brightness of the front panel display, clear the preset stations and the station
names, and set the speaker parameters back to the default setting. Press AMP MENU repeatedly
to display 9 CUSTOMIZE. Use X/x to select the following items.
xDIMMER
You can change the brightness of the front panel display by two ways. Use C/c to adjust the
settings or press DIMMER.
xMEMO. CLR.
You can clear the preset stations and station names, and set the speaker parameters back to the
default setting.
• MEMO.CLR.N (No): Press ENTER to skip back to previous menu.
• MEMO.CLR.Y (Yes): If you press ENTER, "Really? N" appears. To clear the memory, use
C/c to select "Really? Y" and press ENTER. "ALL CLEAR!" is displayed and all settings
such as preset stations and station names will be cleared, and speaker parameters will be reset
to their default settings.
GB
27