Connecting A Computer To The Projector - Casio XJ-H1600 Setup Manual

Getting Ready
3.
Make fine adjustments to the elevation angle of the projector by rotating the front
foot.
4.
Make fine adjustments to the horizontal tile of the projector by rotating the rear feet
3.
Important! Important! Important!
To retract the front foot, hold down the release button and slide the front foot back into the
projector. Never try to forcibly change the front foot position without pressing the release
button.

Connecting a Computer to the Projector

Connect the projector's COMPUTER IN 1 or COMPUTER IN 2 terminal to the RGB terminal of a
computer as shown in the illustration below.
<Projector>
COMPUTER IN 1
terminal
AUDIO IN 1 terminal
Important! Important! Important!
Always turn off the projector and the computer before connecting them.
Take care so the volume level of the computer is not set too high.
NOTE
To connect to an external input source other than a computer (video device, etc.), see the User's
Guide on the CD-ROM that comes with the projector.
COMPUTER IN 2 terminal
AUDIO IN 2 terminal
Audio cable (commercially available)
Bundled mini D-Sub cable
(analog RGB output terminal)
E-14
<Computer>
To monitor terminal
To line output terminal