Table of Contents
Advertisement
Getting Ready
Turning On the Projector
Before performing any of the operations in this section, make sure you first set up the
projector (page 30) and connect to an output device (pages 37 to 40).
AC Power Cord Precautions
Make sure that you use a power source with the same voltage as that specified for the
projector.
Do not share the outlet supplying power to the projector with other devices. If you are
using an extension cord, make sure that the ampere rating of the extension cord is
compatible with the power consumption value of this projector.
Never use the power cord while it is still bundled together.
Never place objects on top of the power cord and do not step on it.
Never pull on the power cord. When unplugging it, grasp the plug.
Use a conveniently located power outlet that you can reach easily when you need to
unplug the projector.
If you need more information about the power supply, contact your original dealer or
authorized CASIO service center.
To turn on the projector
1.
Use the bundled AC power cord to plug the projector into a power
outlet.
Plugging into a power outlet causes the three indicators on the top of the projector to
light amber. After a short while, two of the indicators will go out and only the POWER/
STANDBY indicator will remain lit amber, which indicates the standby state.
Note that the projector will not turn on if you press the [
indicators are lit amber. Wait until the projector is in the standby state before trying to
turn it on.
Power supply connector
Bundled AC power cord
The shape of the plug depends
on your geographical area.
] (power) key while all three
41
Advertisement
Table of Contents
Troubleshooting
