Nothing appears on the display.
Remove batteries and reload them correctly.
Cannot input text.
FUNC key has been
Press ESC to clear FUNC key operation.
Tape does not come out when PRINT is pressed.
Back cover is not closed
Securely close the back cover.
No more tape left in the
Replace the tape cartridge with a new one.
Remove the tape cartridge and pull out the
jammed tape by hand. Cut off excess tape
with scissors, and carefully replace the
cartridge into the label printer.
Never allow the tape outlet to become
blocked and never touch tape as it is being
fed during printing.
Tape comes out when PRINT is pressed, but nothing is printed on it.
Only blank spaces were
Input the text you want to print.
Printing is blurred, blotched, broken, etc.
Improper print density
Adjust the print density setting.
Improper loading of the
Remove the tape cartridge and reload it
Dirty print head or rubber
Clean the printer head and roller.
Ink ribbon is being fed from the tape outlet along with the tape.
Tape cartridge loaded
Remove the tape cartridge and check to
while the ink ribbon is
make sure the ink ribbon is not broken. Next,
take up any slack in the ink ribbon and then
reload the tape cartridge.
Before loading a tape cartridge into the
label printer, always make sure you take
up any slack in the ink ribbon first.
If the ink ribbon is broken, you must
change to another tape cartridge.