Listening To The Radio - Sharp SD-PX2 Operation Manual

Listening to the radio

SD-PX2
ENGLISH
Volume control (See page 16).
E-33
1
Turn on the power and press the TUNER (BAND) button to set the
input to "FM (AM)".
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band.
STEREO
FM stereo
3
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for 0.5 seconds or more, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
When radio interference occurs, auto scan tuning may stop automatically.
Should this happen, tune in manually.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING button again.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "STEREO" indicator.
" " will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button to extinguish the
"STEREO" indicator. The reception changes to mono, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
FM mono AM
FM stereo mode indicator
FM stereo receiving indicator