Reception And Copying Problems - Sharp FO-3150 Operation Manual

A distorted image is
received at the other end.

Reception and copying problems

Problem
The fax machine doesn't
receive documents
automatically.
The printing paper comes
out blank when you try to
receive a document.
The received document is
faint.
Dots appear at regular
intervals on received
documents and copies.
• Noise on the telephone line may cause distortion. Try
sending the document again.
• ECM mode (see page 48) will help prevent distortions
due to line noise. Note that ECM mode must be
turned on in the other machine as well.
• Make a copy of the document on your fax machine. If
the copy is also distorted, your fax machine may need
service.
• Make sure that the reception mode is set to FAX. If
you subscribe to a distinctive ring service, make sure
that the Distinctive Ring function is set to the correct
ring pattern. If you do not subscribe to a distinctive
ring service, make sure that Distinctive Ring is set to
OFF SETTING. (See Distinctive Ring on page 74.)
• Make sure that the document is loaded properly in the
feeder of the transmitting machine. Make a copy or
print a report to confirm the printing ability of your
machine.
• Ask the other party to send higher contrast
documents. If the contrast is still too low, your fax
machine may need service. Make a copy or print a
report to check your machine's printing ability.
• The toner cartridge may need replacement.
• The drum cartridge may be damaged. Replace the
drum cartridge.
Problems and Solutions
Solution
99