Transferring Song Data From An Sd Memory Card To Digital Piano Memory - Casio Privia PX-800 User Manual

4.
To stop playback, press the SONG PLAY/
STOP button.
5.
After you are finished using the SD memory
card, keep pressing the CARD button until its
lamp turns off.
NOTE
• You can change tempo, volume, and pre-count settings
for playback. See "Configuring Settings with the
Keyboard" on page E-21 for more information.
Transferring Song Data from
an SD Memory Card to Digital
Piano Memory
You can use the procedures in this section to transfer
song data from an SD memory card to the digital piano
*1
user area or recorder area.
*1 Music Library Songs 61 to 70
*2 Memory area where songs recorded on the digital
piano are stored.
Supported Data
User Area. . . . . . .SMF format data and song data
converted using SMF conversion
software (CASIO CM2 format)
Recorder Area. . .Song data recorded on the digital
piano (CASIO CSR format)
PREPARATION
• Insert the SD memory card that contains the data you
want to transfer into the digital piano's SD memory card
slot.
IMPORTANT!
• Never perform any operation on the digital piano while
data is being saved to or transferred from an SD memory
card. Performing any operation can cause SD memory
card data to be deleted or damaged, making transfer of
the data impossible.
*2
To transfer song data from an SD memory
card to the digital piano user area
1.
Press the TONE/SONG button so the SONG
lamp is lit.
2.
Use the + and – buttons to display the
number of the user area song (Music Library
song number 61 through 70) to which you
want to transfer the data.
This mark indicates that the currently displayed user area
song number has data stored already.
3.
Hold down the CARD button until its lamp
starts to flash slowly and "LdU" (Load User
area) appears on the display.
4.
Use the + and – buttons to display the file
number of the data you want to transfer to
digital piano memory.
5.
When everything is the way you want, press
the TEMPO/SETTING button to begin data
transfer.
• The message "CPL" (ComPLete) will appear on the
display to let you know when data transfer is
complete. The number of the user area to which the
data was transferred will be shown on the display.
To interrupt an ongoing data transfer operation,
press the CARD button.
If the user area song number you select already
contains data, pressing TEMPO/SETTING in step 5
will display "rEP" (rEPlace) to confirm that you
want to replace the existing data with the data you
are transferring. Press the
the data. To cancel the operation, press the
button in place of the
Using an SD Memory Card
/YES button to replace
/NO
/YES button.
E-31