Sanyo CH0971 Technical & Service Manual page 76

Anti-Mold Filter
How to remove the anti-mold
Cleaning
How to replace the anti-mold
OI-802-23EG
Care and Cleaning (continued)
The anti-mold filter behind the air intake grille should be checked and cleaned at
least once every two weeks.
1. Grasp both ends of the air
filter intake grille, and remove it by
opening towards the front and
pulling towards you.
2. Remove the anti-mold filter
attached to the rear of the air
intake grille.
Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter,
wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.
1. With the FRONT mark of the
filter anti-mold filter at the front,
align the two indentions near
the mark with the hooks at the
rear of the air intake grille, and
then mount the anti-mold filter.
2. Allow the edge of the air intake
grille to slide into the top of the
indoor unit, and then insert it
all the way inside.
3. Press in the bottom right and
left corners of the air intake
grille to attach the indoor unit.
Attach so that the round pins at the top right and left corners of the air intake grille
NOTE
are inserted into the grooves at the top right and left of the indoor unit.
Air intake grille
Anti-mold filter
Anti-mold filter
FRONT mark
Hook
Groove
Pin
Air intake grille
Air intake grille
23