Samsung FE-N300 Series User Manual page 67

PROBLEM
The Cooktop You have a function error code.
control beeps and
displays an F error
code.
The surface units Improper cookware is being used.
will not maintain
a rolling boil or
In some areas, the power (voltage)
will not cook fast
may be low.
enough.
The surface units A fuse in your home may be blown
will not turn on. or the circuit breaker tripped.
The cooktop controls are set
improperly.
Pan does not heat Pan not detected.
up.
Pan too small for proper pan
detection
and only works with low power.
Distance between surface unit and
glass ceramic is too large.
Areas of Food spillover was not cleaned.
discoloration on the
cooktop.
The surface is hot and the model
features a light-colored cooktop.
The surface unit This is normal.
frequently cycles on
and off.
The oven will not The range is not completely
turn on. plugged into the electrical outlet.
A fuse in your home may be blown
or the circuit breaker tripped.
The oven controls have been set
improperly.
The oven is too hot.
POSSIBLE CAUSE
CODE CAUSE
-SE- Touch Button Short Error
-LE-
Low Voltage Error
-ot- Over Temperature Error
Pan Detection Error
- -
CODE CAUSE
-to-
Top Sensor Open Error
(Sensor-Top)
-t - Top Sensor Short Error
(Sensor-Top)
-bo- IGBT Sensor Open Error
(Assy-Inverter Module)
-b -
IGBT Sensor Short Error
(Assy-Inverter Module)
-FL- DC fan motor Error
SOLUTION
• Press touch the on/ff control key sensor. If
the problem persists, disconnect all power
to the range for at least 30 seconds and
then reconnect the power. If this does not
solve the problem, call for service.
• Call for service.
• Use pans which are flat and match the
diameter of the surface unit selected.
• Cover the pan with a lid until the desired
heat is obtained.
• Replace the fuse or reset the circuit
breaker.
• Check to see the correct control is set for
the surface unit you are using.
• Check whether the pots or pans are
suitable for induction.
• Refer to page 29 for proper pan selection.
• Use larger pan or this pan on a smaller
cooking zone. Refer to page 29 for proper
pan selection.
• Check whether the surface unit is properly
positioned and touching the glass cooktop
surface.
• Refer to the section on care and cleaning
of the glass cooktop on page 61.
• This is normal. The surface may appear
discolored when it is hot. This is temporary
and will disappear as the glass cools.
• The element will cycle on and off to
maintain the heat setting.
• Make sure the electrical plug is inserted
into a live, properly grounded outlet.
• Replace the fuse or reset the circuit
breaker.
• See the chapter on operating the oven.
• Allow the oven to cool.
Troubleshooting _67