Basic Operation; Using Tones - Casio Celviano AP-38 User Manual

Basic Operation

Using Tones

The following procedures describe everything you need to
know about selecting and using tones.
Selecting a Tone
This digital piano has a selection of 16 built-in tones.
Tone Buttons
GRAND ELEC
PIANO 1 PIANO 1 ORGAN 1
GRAND HARPSI-
PIANO 2 CHORD
BRIGHT ELEC
PIANO PIANO 2 ORGAN 2
HONKY- VIBRAPHONE
TONK
Variation Tones
Variation Button
Each tone button is assigned two tones: a "normal tone"
(whose name is above the tone button) and a "variation tone"
(whose name is below the tone button). Which tone is selected
when you press a tone button depends on the current status
of the indicator lamp above the VARIATION button, as shown
below.
To select this type of tone:
Normal tone
Variation tone
• Press the VARIATION button to toggle its indicator lamp
on and off.
• Pressing the tone button of the currently selected tone
toggles it between the normal tone and the variation tone.
NOTE
• The tone buttons provide you with a selection of 16 tones that
you can assign to and play on the keyboard.
• The GRAND PIANO 1 tone was recorded with stereo sampling.
• See "Selecting a Variation Tone" for information on selecting
the tones whose names are marked below each tone button.
E-12
AP38_e_08-19.p65
VARIATION
PIPE
button
CHOIR
ACOUSTIC
STRINGS 1 BASS
PIPE SYNTH-PAD
STRINGS 2 RIDE ACO
BASS
The VARIATION button
lamp should be:
Off
On
12
To select a tone
1.
Press the POWER button to turn on the digital
piano power.
2.
Press one of the tone buttons to select the tone
you want.
3.
Use the VOLUME slider to adjust the volume.
• It is a good idea to set the volume to a relatively low
level at first.
• Moving the slider towards MIN decreases volume,
while moving it towards MAX increases volume.
4.
Play something on the keyboard.
• Adjust volume to the level you want as you play.
5.
After you are finished playing, press the POWER
button to turn off power.
NOTE
• The GRAND PIANO 1 tone is selected automatically whenever
you turn on the digital piano power.
Selecting a Variation Tone
The tone buttons that are marked as shown below are for
selecting variation tones.
1.
Press the tone button for the tone you want to
select.
2.
Press the VARIATION button.
• This causes the indicator lamp above the button to
light, which indicates that the variation tone is
selected.
3.
To switch back from variation tone to normal
tone, press the VARIATION button again to the
indicator lamp goes out.
02.6.12, 15:55
428A-E-016A