You can connect the Bathroom Speakers in the following method.
Connecting through the Variable Output (available without an external amplifier)
¦
1. Connect the
VARIABLE AUDIO OUT
2. Connect the
VOL-CTRL
y Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure, you can control the volume of the bathroom speakers.
– The jack that is connected from the Volume Control Box to the TV is a 3.5mm normal Phone jack.
– Volume Control Box switch consists of Tact switch.
✎
Setting the Sub AMP Mode
– 0: Turns the Sub AMP function off (PWM off).
– 1: Determines the Sub volume according to the main volume control. That is, the sub volume is determined according
to the Power On Volume, the Min Volume, and the Max Volume values of the Hotel Mode.
– 2: Determines the volume according to the bathroom control panel setting.
UC6900 호주_중아, UC6000 구주 호텔.indd 13
Connecting the Bathroom Speakers
TV Rear Panel
port of the TV to the Bathroom Wall Speakers of the hotel.
Signal wire : Speaker +
Shield wire : Speaker -
jack of the TV to the Volume Control Box Switch port of the Bathroom Wall of the hotel.
Volume Control Box
VOL+
VOL-
2
1
Speaker
13
English
2010-04-27 오후 2:24:42