Information Codes - Samsung DMT300 Series User Manual

InformatIon coDES

Information codes are displayed to help you better understand what is occurring with your dishwasher.
If your dishwasher have any problem, below CODE SYMBOL light(s) is(are) blinked.
If you see any of the codes below, select the Cancel and Drain option, and then follow the directions under
Solution.
COde SymbOl
For any codes not listed above, call 1-800-SAMSUNG (1-800-726-7864).
meANING
Temperature Sensor
error
Heater error
High temperature
Heating error.
Low-level water error
Water supply error
High temperature
Water supply error
Drain error
Over-level water error
Leakage error
Button error
Door open warning
SOlUTION
Functional error. With the dishwasher empty, add
detergent, and then run a cycle.
If the problem continues, go to your house circuit
breaker panel, set the dishwasher's circuit breaker
switch to off, and then contact an authorized
Samsung service center.
Check whether the water supply valve is closed, the
water supply is suspended or the water inlet valve or
line is frozen or clogged by foreign particles.
If the problem continues, close the water supply
valve, and then contact an authorized Samsung
service center.
Check the temperature of the supplied water. If it
is higher than 176 ˚F (80 ˚C), a functional error may
occur with the dishwasher.
Check whether the drain hose is clogged or folded. If
the problem continues, close the water supply valve,
and then contact an authorized Samsung service
center.
Functional error. Close the water supply valve and
go to your house circuit breaker panel, set the
dishwasher's circuit breaker switch to off, and then
contact an authorized Samsung service center.
Functional error. Turn off the dishwasher and try to
start it again.
If the problem continues, contact an authorized
Samsung service center.
Functional error. Make sure to close the door
properly. If the problem continues, contact an
authorized Samsung service center.
troubleshooting _25