How To Install - Panasonic DH-6SM1 Operating And Installation Instructions

HOW TO INSTALL

Note:
• During installation process, make sure electrical and water supplies are turned off.
1. Where to install the appliance.
• Install the appliance in indoor with frost-free weather proof locations only.
WARNING
• Do not install the appliance away from the wall surface as shown in Figure 2.
• Select a suitable location with easy access of electrical and water supplies.
• Avoid installations which expose the appliance to any of the following conditions:
- Installation in frost.
- Voltage input exceeding the specifi ed voltage.
CAUTION
2. How to remove the Front Plate.
• Make sure the Temperature Control Knob at "Min" position.
• Remove the Screw at the bottom of the appliance.
• Lift up the Temperature Control Knob to make it free. Make sure
the Temperature Control Knob is not detached from the Front Plate.
• Remove the Front Plate fi rst at the bottom and then unhook the top part.
• Remove the "U" Cap from the appliance before installation.
Note:
• Temperature Control Knob is attached to Front Plate
(No need to pull out).
3. How to fi x the appliance.
Please fi x the appliance based on the dimension below:
EN8
DH-6SM1_TH.indb 8 DH-6SM1_TH.indb 8
Be sure to install the appliance on the wall as illustrated in
Figure 1 (vertical position with the inlet pipe and outlet pipe
pointing downward).
Ensure this appliance is not installed at the place where water
existence will lead to smoke emission, ignition, fi re, electric
shock and damage to property.
Screw
157.50 mm
Screw
7.50 mm 120.00 mm
Screw
"U" Cap
182.50 mm
Screw
Screw
13.50 mm
55.00 mm
Figure 1 Figure 2
Temperature Control Knob
Front Plate
Remove the "U" Cap
14/7/2020 7:52:20 PM 14/7/2020 7:52:20 PM