By-Passing The Dsp (Assignable 2; Sending Control Changes (Assignable 1/2 - Casio Privia MA1003-A User Manual

By-passing the DSP
(ASSIGNABLE 2)
While the  (ASSIGNABLE 2) button is on, only the
sound of a specified zone is output without passing
through the DSP.
Common Parameter Information:
5-A Assignable Button 2 Type (Asgn2) (page E-22)
5-B Settings when Asgn2 = DSP Bypass (Dbp) (page
E-23)
NOTE
• For more information about DSP bypass, see the
flowchart under "Master Control Configuration"
(page E-4).
Sending Control Changes
(ASSIGNABLE 1/2)
Since control change is a MIDI message, the target of a
send operation generally is an external MIDI device.
With the  (ASSIGNABLE 1) button, different control
change values can be specified for sending at the points
the button is pressed and when it is released.
With the  (ASSIGNABLE 2) button, different control
change values can be specified for sending at the points
the button is turned on and when it is turned off.
Common Parameter Information:
4-A Assignable Button 1 Type (Asgn1) (page E-22)
5-A Assignable Button 2 Type (Asgn2) (page E-22)
4-B, 4-C, 4-D, 5-B, 5-C, 5-D Settings when Asgn1/
Asgn2 = Control Change Number 0 to 127 (page
E-23)
* You also can configure control change send for the
internal sound source that corresponds to a
particular zone. See the note under "4-B, 4-C, 4-D,
5-B, 5-C, 5-D Settings when Asgn1/Asgn2 = Control
Change Number 0 to 127" (page E-23).
*
Using the Assignable Buttons
E-25