Smart Start IN-HOM S.M.A.R.T. Mobile Quick Reference Manual

S IN-HOM SMART M
ETTING UP THE
1. Connect the power supply cord to the IN-HOM S.M.A.R.T. Mobile device (figure 1)
and plug it into an electrical outlet. The unit will activate and the LCD will display
"Initializing," and then "Ready".
2. If the battery is completely dead, it may take a few minutes to initialize the device.
3. Place the mouthpiece in the nozzle found on top of the IN-HOM S.M.A.R.T. Mobile
device as show in figure 2.
4. The IN-HOM S.M.A.R.T. Mobile device transfers data through a cellular connection. It
is your responsibility to place your device in an area with a good cellular signal. See
your user manual for more details regarding cellular signal strength.
Figure 1 – Power cord
H T T
OW TO AKE A
Make sure the display shows "Ready" or "Test Required." (see images below).
1.
Smart Start recommends drinking WATER before each test to ensure a clean
mouth.
2. Take a deep breath and blow steadily into the mouthpiece until the device stops
beeping and you hear a click. During the test, the display will show the word "Testing
– Keep Blowing."
After testing, the display will show "Analyzing – Please Wait," or other messages
3.
listed that indicate an incomplete test (see next page).
Active Test Window Display
Reminders:

See figure to the right to ensure the
correct face-to-camera position

Drink water prior to every breath test to
ensure a clean mouth.

Make sure you have good lighting in the
room

Do not use a breath freshening agent
before taking a test as most of these
contain alcohol.

It is a violation of your program for another
person take a test on your device.
C S
ONTACT MART
If you have questions concerning your IN-HOM S.M.A.R.T. Mobile device, call
Smart Start toll free at 1-800-880-3394.
IN-HOM™ S.M.A.R.T. Mobile Quick Reference Guide
:
EST
S
TART
:
OBILE UNIT
Figure 2 – Mouthpiece installation
Ready (out of test window)