Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jimi LL301
Summary of Contents for Jimi LL301
- Page 1 LL301 Wireless Tracker for Asset Vehicles User Manual Version:V1.2 Read this manual carefully prior to use to ensure fast and correct operation of the product. No prior notice will be given for any changes made to the appearance, color, or accessories of the product.
-
Page 2: Specification
Introduction Features Power saving Multi-GNSS positioning Large-capacity battery Remote listening Tamper alert Cover removal alert Humidity and temperature detection and alert Specification IPx4 protection Communication system: Specification LTE FDD : B1//B3/B7/B8/ LL301E B20/B28 Communication system: GSM: 900/1800MHz LTE FDD : B1//B3/B7/B8/ LTE FDD : B1/B2/B3/B4/B5 LL301E B20/B28... -
Page 3: Packing List
1*Red (work status) and LEDs 4*Blue (battery level) Operating temperature –20℃ to +70℃ Dimensions (LxWxH) 108x61x30mm Packing List Standard Name Unit Remarks Tracker User Manual Charging cable 3M Tape Bracket Note: Please check the received package against the packing list. The contents are subject to actual items. - Page 4 Battery switch Cover removal detection switch emperature and Humidity sensor SIM card holder Note: Once the anti-tamper Anti-tamper button button is released, a tamper alert will be triggered. Power LED Plug for power button and USB port...
-
Page 5: Power Led
GSM LED Status Meaning GSM initializing/No GSM signal/ Fast blink No SIM card Logging in to platform Slow blink Device in a call Solid on Note: The GSM LED goes off 3 minutes later after the device is turned on. The GSM LED will light up by short pressing the power button of the device in the power-on state and go off after 60 seconds. -
Page 6: Tamper Alert
If the device is not charging, then: Strength LED1 LED2 LED3 LED4 Undervoltage 0–25% 25–50% 50–75% 75–100% Note: The power LED goes off 3 minutes later after the device is turned on. The power LED will light up by short pressing the power button of the device in the power-on state and go off after 20 seconds. - Page 7 spring back, which will trigger the device to send out a tamper alert. In the long standby mode, the device will enable tracking for 20 minutes after the alert message is sent out. The tamper alert feature can be disabled by command. Cover Removal Alert When the front cover of the device is in place, the cover removal detection switch will remain press-down.
-
Page 8: Power On And Off
①Notch ②Confirm thatthe battery switch is off ③Insert the SIM Power-On and -Off Power-on: Press the power button for 3 seconds (prerequisite: the battery switch is ON). Power-off: Press the power button for 3 seconds. Installing the Device The device has a strong magnet built inside. It can attach to any ferromagnetic material. - Page 9 Bracket 3M Tape Platform Operations After binding the device on the location service platform or mobile app designated by the dealer, you can monitor it, configure it, and do more to it via the platform or app. Logging In to Service Platform You can configure and control the device via the designated location service platform.
-
Page 10: Troubleshootintg
Troubleshootintg When a problem arises, you can troubleshoot it by the following solution. If the problem persists, please don't hesitate to contact your dealer or service provider. Common Possible Causes Solutions Issues The device is used in an Try it in a place where area where radio waves is satellite signals can be well hard to reach, such as near... -
Page 11: Warranty Instructions And Service
Warranty Instructions and Service Special Statement ① No prior notice will be given if the product is upgraded due to technological reasons. ② The appearance or color of the product is subject to the actual. ③ The warranty card applies to the services of repair, replacement, and refund of the product with the following IMEI. -
Page 12: Fcc Warning
For vehicle trackers: As of January 1, 2016, the warranty lasts for 2 (two) years for repair from the date of purchase, including one year for replacement. The specific terms are: A full replacement, including accessories, if the product is found defective during unpacking check;... - Page 13 radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Need help?
Do you have a question about the LL301 and is the answer not in the manual?
Questions and answers
how we set timer on this device means minutes and seconds for data sending.