Protection Against Overheating - Vitek VT-1303 Instruction Manual

Hide thumbs Also See for VT-1303:

Manual instruction (6 pages)

Table Of Contents

Table of Contents

Available languages

ENGLISH

IN PRODUCTION AREAS AND WORK SPACES IS

PROHIBITED.

USING THE HAIRDRYER

After unit transportation or storage at low

temperature it is necessary to keep it for at

least three hours at room temperature before

switching on.

•

Unpack the unit and remove any advertising

stickers that can prevent the unit operation.

Unwind the power cord completely.

•

Before switching the unit on, make sure that

your home mains voltage corresponds to the

unit operating voltage.

•

Insert the power plug into the mains socket.

Switching hair dryer on

Before switching the appliance on make sure

power supply voltage meets operating voltage of

the appliance.

• Insert power cord plug into wall outlet.

• Select operating speed you need using airflow

speed switch (1):

0 = the hairdryer is switched off;

= low speed;

= high speed;

• Select airflow temperature you need using

heating degree switch (2).

= slight heating cold air

= medium heating

= maximal heating

= Cool shot function, press and hold the

cool shot button for fixing your hairstyle.

Note: - when the hairdryer is switched on, the pi-

lot light (7) lights up.

Taking care about your hair

Before drying and setting your hair, wash them

with shampoo, dry with towel to remove excessive

moisture and brush for better results.

Fast drying

Set switch (2) into position of maximal heating

(position

), select airflow speed you need us-

ing switch (1) and dry your hair out a little bit.

Shake off excessive moisture by hand or using a

brush and continuously move the hair dryer over

your hair.

Straightening your hair

Set switch (2) into position of maximal heating

(position

), select airflow speed you need using

switch (1) and dry your hair out a little bit. When

your hair are almost dry, install concentrating noz-

zle (4), reduce degree of air heating by switch (2)

and airflow speed by switch (1).

IM VT-1303.indd 4

Divide your hair into locks and layers and start

straightening from the lower layers. Using a flat

or a round hairbrush, brush the hair downwards

while directing hot air from the nozzle (4) at it. In

this way, slowly straighten each lock from root to

end. After you finish straightening the locks of the

lower hair layer, start straightening the locks of the

middle layer and finish with the locks of the upper

hair layer.

Natural waving structure of your hair

Set switch (2) into position of slight heating (po-

sition ), then set switch (1) into position

a lock between your fingers tightly, turn it to di-

rection of its natural curliness, then dry the lock

out by directing air jet between the fingers. After

getting the shape you need, press cool shot but-

ton

(2) and fix each lock.

Volume styling

Using hair dryer in any mode of heating/any speed

from slight to maximal, dry out hair roots begin-

ning from backside of your head.

Styling your hair

Set switches (1,2) into positions of slight heating

and slow speed correspondingly, attach concen-

trating nozzle (4) to provide directed airflow.

Divide your hair into locks and create a required

hair style using a round hairbrush. During hair styl-

ing direct the air flow straight onto your hair in the

desired direction.

If necessary, direct air jet on each lock for 2-5 sec-

onds to fix it. Time of setting locks you should de-

termine on your own taking into account type of

your hair.

«Cool shot»

This model is equipped with function of "cool shot",

which can be used for fixing your hairstyle. Press

and hold "cool shot" button (3)

to protect the hairstyle you have created.