Connecting Antennas; Mw Indoor Loop Antenna; Fm Indoor Antenna; Fm Outdoor Antenna - Philips LX700 User Manual

Connecting antennas

MW Indoor Loop Antenna

Connect the supplied MW loop antenna to the MW
jack. Position the loop antenna to receive the clearest
sound.
Fix the claw
MW
to the slot

FM Indoor Antenna

Connect the supplied FM antenna
to the FM jack. Move the antenna
in various directions until the
clearest signal is received.
Note:
– Keep the antenna as far away as
possible from the TV, VCR or any
radiation source to prevent unwanted noise.

FM Outdoor Antenna

For better FM reception, use a 75 ohm coaxial cable (not
supplied) to connect the system to an outdoor FM antenna
as shown.
Connecting from a DVD and
additional components
To listen to playback from your DVD or SACD player.
Option 1
6 CHANNEL-DVD/SACD IN
Use the supplied audio cables to connect the 6 CHANNEL-
DVD/SACD IN jacks to the corresponding Multichannel
AUDIO OUT on your DVD or SACD player.
About 6 CHANNEL-DVD/SACD IN
The 6 CHANNEL-DVD/SACD IN can be used to connect
from a device with a built-in multichannel decoder (e.g.
Dolby, Digital,DTS, etc) and 6-channel output, i.e. a high
end DVD/SACD player
When using the 6 CHANNEL-DVD/SACD IN audio
input, the Receiver works as a multichannel amplifier. The
source reproduces surround sound and sends it to the
Receiver divided into the necessar y channels. Therefore
the SURROUND button has no effect since the provided
signal is already multichannel.
From a source which is connected to the 6 CHANNEL-
DVD/SACD IN, audio input cannot be recorded.
OR
Option 2
DIGITAL IN
Connect the OPTICAL or COAXIAL jack to the
DIGITAL OUT jack on the DVD or SACD player. You
will need to set the Receiver's digital input to the jack
you connected to (refer to "System Setup - Digital Input")
Connecting additional components
For listening to the playback from other audio/ visual devices
through the Reveiver
Connect the AUDIO IN (TV/AV or AUX) jacks to the
AUDIO OUT jacks on the TV, VCR or other audio/visual
device.
AND/OR
Connect the DIGITAL IN ( OPTICAL or COAXIAL)
jack to the DIGITAL OUT jack on other audio/visual
device. You will need to set the Receiver's digital input to the
jack you connected to ( refer to "System Setup - Digital
Input").
For recording to an external recording device
Connect the AUDIO OUT jacks to the AUDIO IN jacks
MW
on an analog recording device.
AND/OR
Connect the DIGITAL OUT jack to the DIGITAL IN
jack on a digital recording device. You can only make a digital
recording from digital signal received from the DIGITAL
IN jack on this receiver.
Connections
C
9
ONNECTIONS