Table of Contents
Advertisement
As soon as possible after diving, the regulator should be rinsed completely with fresh water whi-
le connected to a bottle and pressurized with air.
Rinsing alone, however, will not clean up the regulator sufficiently. In order to clean up the con-
troller as thoroughly as possible, TDS recommends:
1. Connect the regulator to a loaded SCUBA bottle, open the bottle valve to pressurize the regu-
lator and fully immerse the first and second stages in a freshwater bath.
2. After the regulator has been properly soaked, it is important to rinse it vigorously by rinsing
the main spring cavity of the first stage regulator (only environmentally unsealed models), the
second stage nozzle and the openings in the front cover of the second stage with a strong
stream of water. This will remove salt and mineral deposits that were released during soaking.
WARNING:
diaphragm and/or internal valve.
CAUTION:
without pressure. Doing so will allow moisture to enter and will require the regulator to be returned to an Authori-
zed TDS Technician for repair.
3. Properly disconnect the regulator and clean it as dry as possible. Take it into the first stage to
make sure all remaining moisture drains from the second stages and accessories.
4. DO NOT leave the regulator exposed to direct sunlight for extended periods of time.
5. When the regulator is completely dry, store it in a box of clean or sealed equipment inside
a plastic bag. Do not store it where you may be exposed to extreme heat or an electric motor,
which produces ozone. Prolonged exposure to extreme heat, ozone, chlorine and ultraviolet rays
can cause premature degradation of rubber parts and components.
6. Never store the regulator while it is still connected to the bottle valve.
WARNING:
of the regulator. Do not expose any part of the regulator to aerosols, as some aerosol thrusters attack or degrade
rubber and/or plastic components.
12
12
TDS
If you use a garden hose to clean it, DO NOT use the high pressure jet as this could damage the
Do not press the purge button or loosen the int of the first stage if the regulator is submerged
Do not use any type of solvent or petroleum-based substance to clean or lubricate any part
www.cascoantiguo.com |
Technical dive system ■ 12
www.tdsdive.com
Advertisement
Table of Contents
