Table of Contents
Advertisement
Connections
Step 1:
Placing speakers and
subwoofer
For best possible surround sound, locate your
speakers and subwoofer as follows:
●
Place the left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
●
Place the subwoofer on the floor.
Notes:
– To avoid magnetic interference, position the
speakers, subwoofer as far as possible from the
main unit, TV set or other radiation source.
– Allow adequate ventilation around the DVD
System.
IMPORTANT!
The type plate is located on the bottom
of the system.
To avoid overheating of the system, a
safety circuit has been built in. Therefore,
your system may switch to Standby
mode automatically under extreme
conditions. If this happens, let the system
cool down before reusing it.
10
Step 2:
Connecting speakers
and subwoofer
●
Connect the supplied DIN cable to DVD player's
DIN jack and the left speaker's DIN jack.
●
Connect the supplied speaker wires of the right
speaker to SPEAKER RIGHT on the left speaker,
red wire to red jack ( "+" ), black wire to black
jack ( "-" ). Fully inser t the stripped portion of
the speaker wire into the terminal as shown.
●
Connect the supplied speaker wire of the
subwoofer to SUBWOOFER OUT on the left
speaker, green wire to green jack ( "+" ), white
wire to white jack ( "-" ).
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
6
8
AC MAINS ~
Advertisement
Table of Contents
