Ec Declaration Of Conformity; Maintenance - Makita 9902 Instruction Manual

Hide thumbs Also See for 9902:
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
Sanding operation (Fig. 8)
Hold the tool firmly with both hands. Turn the tool on
and wait until it attains full speed. Then gently place
the tool on the workpiece surface. Keep the belt flush
with the workpiece at all times and move the tool
back and forth. Never force the tool. The weight of the
tool applies adequate pressure. Excessive pressure
may cause stalling, overheating of the motor, burning
of the workpiece and possible kickback.
Connecting to Makita vacuum cleaner or dust col-
lector
Cleaner sanding operations can be performed by
connecting the belt sander to Makita vacuum cleaner
or dust collector.
When connecting to Makita vacuum cleaner (Model
406/431), an optional hose 28 mm in inner diameter
is necessary. See Fig. 9.
When connecting to Makita dust collector (Model
420/420S), the optional hose is not necessary. You
can connect the belt sander directly to the hose of
the dust collector.
Belt sander stand (optional accessory) (Fig. 10)
The belt sander stand is handy for sanding small
workpieces or deburring workpieces.
Sanding shoe (optional accessory) (Fig. 11)
The sanding shoe readily allows you to sand work-
pieces more evenly.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes (Fig. 12 & 13)
Replace carbon brushes when they are worn down to
the limit mark. Both identical carbon brushes should
be replaced at the same time.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.
Noise and Vibration of Model
9902/9903/9920/9404
The typical A-weighted sound pressure level is
71 dB (A).
The noise level under working may exceed 85 dB (A).
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards
or standardized documents,
HD400, EN50144, EN55014, EN61000
in accordance with Council Directives, 73/23/EEC,
89/336/EEC and 98/37/EC.
Yasuhiko Kanzaki
Director
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
2
.
CE99
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

990399049920

Table of Contents