If You Need Help - Panasonic DMR-EX95V Operating Instructions Manual

If you need help

CUSTOMER SERVICE
ERROR CODES
The error code H , U
or F appears.
Error code U50
Error code U59
Error code U61
Error code U71
Error code U72
Error code U73
Error code U88
HARD ERR
The unit automatically switches
to Standby mode.
FUNCTION
Unit not functioning.
The disc cannot be ejected.
Access to the HDD is slow.
78
Should problems occur, please try to resolve them by referring to the error sources
described here. If this does not help, you should contact your dealer or customer
service.
Normal disc revolution sounds, atmospheric interference during reception, picture
interference while fast-forwarding, and limited reception of the satellite programs
are not signs of a defective unit.
If the disc cannot be played due to poor quality, try it again with a disc from
Panasonic.
The unit is malfunctioning.
The numbers following H, U or F indicate the status of the unit.
Switch the unit to Standby mode with
If the unit does not switch to Standby mode, press
unplug it for a minute and then plug it back in.
Press to switch on the unit. If this does not solve the problem, contact customer
/ I
service with the displayed error code.
Short-circuit in the active aerial. Check the connection.
The unit is hot and switches to Standby mode for safety reasons.
Wait approx. 30 minutes until the message disappears. Place the unit in a well
ventilated location. Do not block the vents at the back of the unit.
The unit has found an error during recording or playback without an inserted disc.
The unit proceeds with the recovery procedure.
This procedure restores the normal operating mode. The unit is not defect. Please
wait until the message goes off.
The connected unit is not suitable for connection to HDMI.
The HDMI connection does not work perfectly.
The connected unit is not suitable for connection to HDMI
The HDMI cable is too long
The HDMI cable is broken.
A problem occurred during recording or playback of a disc.
The unit is not defective, but is performing a restore procedure.
Wait until the error message disappears from the display.
The unit is not functioning properly.
Switch the unit off and back on again.
If this does not solve the problem, contact customer service.
One of the unit's safety devices may have been activated.
Press to switch on the unit.
/ I
Check the connection to the power supply.
The unit is in Standby mode for a Timer programming via external units. EXT-L
appears in the display.
Press EXT LINK to switch off recording standby mode.
To cancel a recording prematurely, stop the transfer of the recording signal on the
external unit.
Press EXT LINK to switch off recording standby mode.
The unit is currently recording.
With the unit switched off, press STOP
and hold for about 5 seconds. Contact your dealer.
The above procedure cannot be executed if the child protection feature is activated.
Switch off child protection.
The HDD is in SLEEP mode. ("HDD SLP" appears in the display of the unit.)
.
/ I
/ I
.
and CH on the unit at the same time
for approx. 10 seconds or
.
Page
52
6