Error Displays - Panasonic DMR E50 Operating Instructions Manual

Error messages
No Disc.
This is a non-recordable disc.
This disc is not properly formatted.
Formatting is necessary using DISC
INFORMATION.
Please check write protect tab on the
disc.
Contents of this disc are protected.
Cannot finish recording completely.
Cannot record on the disc.
Please set clock.
This disc may not be played in your
region.
Your selection exceeds the recorder's
rating limit.
Error has occurred.
Please press ENTER.
Please check the disc.
Please change the disc.

Error displays

Causes and solutions
≥You haven't inserted a disc. Correctly insert a disc that this unit can play. (page 20)
≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.
(page 20)
≥The unit cannot record on the disc you inserted. The unit cannot record onto finalized
DVD-R, DVD-Video, CDs or video CDs.
Insert a DVD-RAM or unfinalized DVD-R. (page 10)
≥You inserted an unformatted DVD-RAM.
Format the disc with this unit. (page 39)
≥The write protect tab on the cartridge is set to
"PROTECT".
Use a ballpoint pen or similar to release the
write protection.
≥The programme is write-protected.
Release the protection with the direct navigator. (page 43)
≥The disc is write-protected.
Release the protection with the disc protection sub menu of DISC INFORMATION.
(page 38)
≥The programme was copy-protected.
≥The disc is full.
≥Recording was not completed for some other reason.
≥The disc is scratched. Use another disc.
≥The disc is dirty. Clean the disc as described in these operating instructions. (page 69)
≥The clock is not set correctly. Reset the clock using "Manual Clock Setting". (page 64)
≥You tried to play a disc with a region number different from this unit's region number.
This unit can play only play discs with the region numbers compatible with this unit.
(page 10)
≥A ratings level has been set for DVD-Video with this unit. Temporarily unlock the unit
with "Ratings" in the disc menu. (page 62)
≥You can operate the unit using the [ENTER] (10) only.
≥After you press the [ENTER] (10), turn off the unit and then turn it on. Recovery starts.
≥Check the discs for dirt or scratches. (page 69)
≥You can operate the unit using the [<, OPEN/CLOSE] (39) only.
≥Press [<, OPEN/CLOSE] (39) to open the tray and eject a disc, the unit becomes off.
≥To continue play or recording, insert an another disc.
73
PROTECT