Panasonic 3000 Operating Instructions Manual page 30

INSTALLING YOUR MACHINE
Programming or Retrieving Parameters via Email
Explanation of Contents
(1) To
From
Subject
(2) @sender to @end
(3) @select-domain to @end
(4) @relay-domain to @end
(5) @system to @end
NOTE
1. The machine cannot be programmed via email while it is communicating or printing.
2. Some email applications automatically insert a line feed in the middle of a line when the number of characters in
a line exceed a specific number. Turn "Off" the automatic line feed, or define the number of characters per line
to prevent a line feed, or the data will be ignored.
30
: The DP-2500/3000's email address
: This field is normally not visible when creating new email message(s). It is your default
email address for retrieving the Internet Parameters and for error message notification.
(Can be programmed with the configuration tool of your email program.)
: To Store data, type: #set parameters(password)#
: Defines the Sender information to be set in section (2) between @sender to @end block.
Register up to 24 User Names and their Email Addresses for the Sender Selection
feature (see page 83).
Separate each data field with a semicolon (;). (If the remaining fields are to remain blank,
insert a semicolon (;) for each blank field)
The data string for each Sender Selection should be defined within a single line.
The syntax is: <Sender Selection Number>;<User Name>;<Email Address>
(a) 01 to 24: Indicates the Sender Selection Numbers
(b) User Name (25-characters maximum)
(c) Email Address (60-characters maximum)
: Defines the Selectable Domains to be set in section (3) between @select-domain to
@end block. Register up to 10 Domain Names that can be selected during manual email
addressing by pressing the Domain Key
The syntax is: <Number>;<Domain>
: Defines the Domain Names to be set in section (4) between @relay-domain to @end
block. Register up to 10 Domain Names that have been authorized to access your
Internet Fax for Relayed XMT Request. (30-characters maximum)
: Defines the Internet Parameters to be set in section (5) between @system to @end
block. Register the following Internet Parameters.
(a) Default Domain (30-characters maximum).
The syntax is: domain; <Default domain name>
(b) Manager's Email Address (60-characters maximum).
The syntax is: manager; <Manager's Email Address>
(c) Relay XMT Password (10-characters maximum).
The syntax is: relay; <Relay XMT Password>. Quotation marks " " enclosing the
password, are required, as shown in the example above.
(d) Remote Password (10-characters maximum).
The syntax is: remote; <Remote Password>. Quotation marks " " enclosing the
password, are required, as shown in the example above.
(see Note 1) (see Note 2)
. (30-characters maximum)