Multi Channel Input Is Selected As Source; Switching Between Digital/Analog Inputs - Onkyo TX-DS474 Instruction Manual

Selecting a sound source
1
POWER SUR MULTI-CH
MODE
SLEEP DIMMER INPUT
INPUT SELECTOR
DVD TAPE TUNER PHONO C D
TUNER
VIDEO-1 VIDEO-2 GROUP PRESET
C D DVD
DISC
TAPE
CH SEL
TEST
TONE
LEVEL VOLUME
MUTING
REMOTE CONTROLLER RC-385S
2
LEFT CENTER
SUBWOOFER
POWER SUR MULTI-CH
MODE
SLEEP DIMMER INPUT
INPUT SELECTOR
DVD TAPE TUNER PHONO C D
TUNER
VIDEO-1 VIDEO-2 GROUP PRESET
C D DVD
DISC
TAPE
CH SEL
TEST
TONE
LEVEL VOLUME
MUTING
REMOTE CONTROLLER RC-385S
DVD Player
1
DVD ANLG
DVD DIG1
2
MULTI-CH
INPUT
RIGHT
L-SUR R-SUR
CH SEL
TEST
TONE
LEVEL
TX-DS474
DIGITAL 2
( COAXIAL )
DIGITAL 1
( OPTICAL )
DVD
DVD DIG2
DIGITAL 1
When Multi channel input is selected as a source
Follow the steps below to adjust the level of each speaker if you
have selected MULTI-CH INPUT.
1. Press MULTI-CH INPUT button on the remote controller.
You cannot select any Surround mode.
2. Press the CH SEL button to select the desired speakers.
3. Use the LEVEL π/† button to change the volume level of
the speakers.
You can adjust the volume level of each speaker individually. Adjust
the level while listening to the sound in the listening position.
You can adjust the level of the front, center, and surround speak-
ers in the range between –12dB and +12dB.
You can adjust the subwoofer level in the range between –30dB
and +12dB.
Switching between digital and analog inputs
Either a digital or analog device can be connected to the digital
connector. Follow the steps below to select digital or analog
according to the type of the connected device.
Assume that you have connected a DVD player to the DIGITAL 1
connector.
1. Press the Input Selector button (DVD) repeatedly to select
"DVD DIG1."
Pressing the DVD button repeatedly changes the display as
shown in the illustration on the left.
ANLG : Analog input
DIG1 : Digital input (DIGITAL 1 (OPTICAL))
DIG2 : Digital input (DIGITAL 2 (COAXIAL))
If an analog device is connected, press the Input Selector button
to select "ANLG."
You can switch between digital and analog for the DVD, VIDEO-
1, 2, and CD input sources.
To cancel a digital input assignment, press the corresponding input
selector button until "ANLG" is displayed.
Even when the digital inputs are used, the analog connecting cables
must be left in place. Otherwise, the audio output from TAPE OUT
and VIDEO-2 will not work. (See page 7.)
Warning:
Do not play CD-ROM discs that contain computer data as they
may damage the speakers when the sound is amplified by the
receiver.
17