One antenna/one LNB configuration
Select this alternative if you have one (1) LNB mounted on the an-
• Press opt to view the predefined channel.
Select the correct LNB type for your configuration. The most com-
mon values, including Universal LNB, are selectable with the cur-
sor left and cursor right buttons.
LNB offset voltage
If the cable from the antenna is very long, the voltage at the LNB
could be too low to change the polarisation. You can increase the
voltage to the LNB by 0.5 V.
Select one of the preprogrammed satellites.
Select one of the predefined channels and adjust the antenna until
you have a TV picture from the predefined channel visible in the
• Press select to confirm all settings and continue to the channel
• Select alternative "Automatic Search".
• Press select to start the search process.
Channel search in progress
This menu will be shown as long as the Mediamaster is searching
for TV and radio channels.
All channels found will be listed on the screen.
Please note that the search procedure may take a few minutes. You
can cancel the search at any time by pressing select.
When the search procedure has ended, a message will tell how
many TV and radio channels have been found.
• Press select to continue.
The time is adjusted by using cursor up/cursor down, ± 1/2 an hour
at a time. You can also adjust the minutes by using cursor left/cur-
• Press select to finish the first time installation and to open the