Subscribe to Our Youtube Channel
Related Manuals for ACME LED-HC50 II
Summary of Contents for ACME LED-HC50 II
- Page 1 LED-HC 50 II 毅丰 2014.05.10 受控正本 LED-HC50 II User Manual Please read the instructions carefully before use Innovation, Quality, Performance...
- Page 2 LED-HC 50 II LED-HC 50 II...
- Page 3 LED-HC 50 II LED-HC 50 II TABLE OF CONTENTS 1. Safety Instructions Declaration of Conformity 2. Technical Specifications We declare that our products (lighting equipments) comply with the 3. Function following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC.
- Page 4 LED-HC 50 II LED-HC 50 II 1. Safety Introductions 9. Fixture Cleaning The cleaning of internal must be carried out periodically. Cleaning frequency Please read the instructions carefully which includes depends on the environment in which the fixture operates: damp, smoky or important information about the installation, operation and particularly dirty surrounding can cause greater accumulation of dirt.
- Page 5 LED-HC 50 II LED-HC 50 II 2.Technical Specifications 8. Troubleshooting A compact LED controller for all kinds of DC 24V passive RGB Fixtures. Following are a few common problems that may occur during operation. Here are Come with switch power supply inside some suggestions for easy troubleshooting: Built-in programs under Master/Slave mode triggered by music.
- Page 6 LED-HC 50 II LED-HC 50 II 4. Installation 7. DMX512 Connection 1. Ensure that mains power supply is off before installing or wiring the LED fixture The DMX 512 is widely used in intelligent lighting control, with a maximum of 512 2.
- Page 7 LED-HC 50 II LED-HC 50 II When you set the address by DMX controller and dip-switch at the same time, the order of the DMX controller will be invalid. A. DMX address setting by dip-switches 1. Set the start address by dip-switch as the diagram below 2.
- Page 8 LED-HC 50 II LED-HC 50 II C. Remote DMX address setting by CA-T DMX TESTER 6. How to control the fixture The fixture can be set the DMX address remotely by CA-T DMX TESTER. Please There are three ways to control the fixture refer to the CA-T user manual to set the DMX address to the fixture.
Need help?
Do you have a question about the LED-HC50 II and is the answer not in the manual?
Questions and answers