Table of Contents
Advertisement
Select "List" and press ENTER to display the direct Key assignment
list.
Select "OK" and press ENTER to close the window.
To close the List window, press CANCEL on the remote.
Adjust (Source)
Picture
Brightness
Adjusts the brightness level or the back ras-
ter intensity.
Contrast
Adjusts the intensity of the image according
to the incoming signal.
Saturation
Adjust saturation at the white peak.
Color
Increases or decreases the color saturation level (not available for RGB).
Hue
Varies the color level from +/- green to +/-blue. The red level is used as
reference. This adjustment is only valid for Video and Component in-
puts (not available for RGB).
Sharpness
Controls the detail of the image for Video (not available for RGB and
Component).
V-Aperture
Adjusts edge enhancement in the vertical direction. (not available for
RGB)
Gamma Correction
This option corrects gamma. Select the appropriate item.
NTSC .......................... Setting for NTSC signals
Graphics ..................... Setting for Computer Graphics
Graphics/NTSC ........... Setting for both Computer Graphics and NTSC sig-
nals (Default value)
PAL/SECAM 2.8 .......... Setting for PAL and SECAM signals at the gamma
value of 2.8
PAL/SECAM ................ Setting for PAL and SECAM signals
Natural 1 ..................... Setting for Video and S-Video signal
Natural 2 ..................... Setting for component signal (γ value 2.2)
White Balance
Color Temperature
This feature adjusts the color temperature using the slide bar.
Move the slide bar to the right to increase the color temperature for
a bluish image; to the left to decrease it for a reddish image.
Brightness
Brightness for each color (RGB) is used to adjust the black level of
the screen.
Contrast
Contrast for each color (RGB) to adjust the white level of the screen.
Signal Level
R/G/B, Y/Cb/Cr or Y/Pb/Pr Gain:
Adjust RGB, Component or HDTV Gain to match multiple projector
color uniformity.
Image
Pixel Adjust (when Auto Adjust is off)
Displays the Clock and Phase adjustments.
Clock ............ Use this item with the "Auto Adjust off" to fine tune the com-
puter image or to remove any vertical banding that might ap-
pear.
Phase ........... Use this item to adjust the clock phase or to reduce video
noise, dot interference or cross talk. (This is evident when
part of your image appears to be shimmering.) Use the
buttons to adjust the image.
Use "Phase" only after the "Clock" is complete.
NOTE: When Auto Adjust is turned ON on the Page 4 of Setup, the Clock
adjust is not available on this Pixel Adjust screen.
E – 32
and
Advertisement
Table of Contents
