Magnadyne M4-LCD Operation And Installation Manual page 3

Am/fm/wb stereo receiver with disc player and touch screen controls
Hide thumbs Also See for M4-LCD:
Table of Contents

Advertisement

Warnings
• The driver should neither watch the display nor operate
the system while driving.
Watching the display or operating the system will distract
the driver from looking ahead of the vehicle and can cause
accidents. Always stop the vehicle in a safe location
and use the parking brake before watching the display
or operating the system. In some states and countries,
passengers are also prohibited from watching the display.
• Never install the product in a location where it interferes
with your field of vision.
• This unit has a cooling fan to decrease the internal tem-
perature. Do not mount the unit in a place where the cool-
ing fan on the unit is blocked. Blocking these openings will
inhibit the cooling of the internal temperature and result in
damage to the unit.
• Use the proper power supply. This product is designed
for operation with a negative grounded 12V DC battery
system. Never operate this product with other battery
systems, especially a 24V DC battery system. If the prod-
uct is used with the improper system it may cause a fire
or an accident.
• This product must be installed and used in accordance
with this manual. Any alterations to this product that
enables it to be used in any way other than intended
or designed could distract the driver and result in an
accident causing injury or death. Magnadyne Corporation
disclaims any and all liability that may result from failure
to install and operate in any other manner in which this
unit was intended.
Caution
• FCC
REGULATIONS
UNAUTHORIZED CHANGES OR MODIFICATIONS
TO THIS EQUIPMENT MAY VOID THE USER'S
AUTHORITY TO OPERATE IT.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE.
• THIS DEVICE IS INTENDED FOR CONTINUOUS
OPERATION.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK AND ANNOYING INTERFERENCE, USE
ONLY THE RECOMMENDED ACCESSORIES.
STATE
THAT
ANY
• Do not disassemble, modify the unit or attempt to repair
the product yourself. If the product needs to be repaired,
consult your dealer.
• Do not install the unit in a place exposed to direct sunlight
or excessive heat or humidity. Avoid places with too much
dust or the possibility of water splashing.
• Backing Up Your Vehicle
Do not backup your vehicle while looking at the monitor.
Always look in the direction of your vehicle's motion.
Use the monitor only as an aid in safety confirmation.
The actual distance may be different than it appears in the
monitor. The range of the image in the monitor is limited.
Always be aware that blind spots may exist and not appear
at all times on your monitor.
The product is intended to assist in safe driving and
allows the driver to have a broader field of vision dur-
ing backup. You, as the driver, are solely responsible
for the safe operation of your vehicle and the safety of
your passengers and pedestrians, and abiding all state
and local traffic regulations. Do not use any features
of this system to the extent it distracts you from safe
driving. Your first priority while driving should always
be the safe operation of your vehicle. Magnadyne will
not accept any responsibility whatsoever for accidents
and/or injuries resulting from failure to observe these
precautions or safety instructions.
Liquid Crystal Panel
• Any harsh impacts may damage the liquid crystal panel.
• Usage temperature range: 32
temperature is very cold or very hot, the image may not
appear clearly or may move slowly. Also, movement of the
image may seem to be out of synchronization or the image
quality may decline in such environments. Note that this is
not a malfunction or problem.
• Sudden changes in the temperature inside the vehicle such
as those which occur immediately after the vehicle's air
conditioner or heater has been turned on may cause the
inside of the liquid crystal panel to cloud over due to water
vapor or it may cause condensation (droplets of water) to
form and, as a result, the panel may not work properly.
Do not use the unit while these symptoms are evident.
Instead, leave the unit standing for about an hour, and
then resume or start use.
• If the screen of this unit is dirty, wipe the dirt off with a
cloth moistened with a mild cleaner. Note: Applying spray
cleaner directly to the unit may affect its mechanical parts
or cause an electrical shock. Wiping the screen with an
abrasive cloth or using a volatile liquid such as thinner or
alcohol may scratch or damage the surface of the screen.
F to 104
F. When the
0
0
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M3-lcd

Table of Contents