Error Messages - Kyocera FS FS-3900DN Operation Manual

Error Messages

Message
Add paper MPTray
Call service
F###
Call service
####:0123456
Cassette #
not loaded
Check waste
toner box
Clean printer
Press GO
Close
left cover
Close
rear unit
Close
top cover
Duplex disabled
Press GO
OPERATION GUIDE
The following table lists errors and maintenance messages that you can be
dealt with by yourself. If Call service appears, turn off the printer,
disconnect the power cord, and contact your service technician.
Some errors cause the alarm to sound. To stop the alarm, press [Cancel].
The paper has run out in the paper source displayed. Supply paper according to
the paper source displayed (paper cassettes, MP tray, optional paper feeders, or
optional envelope feeder [FS-3900DN/FS-4000DN only]).
This message is displayed alternately with messages indicating the printer status,
such as, Ready, Please wait, Processing, Waiting, and FormFeed Time
Out.
F### represents a controller error (#=0, 1, 2, ...). Call for service. The printer does
not operate when this message is displayed.
#### represents a mechanical error (#=0, 1, 2, ...). Call for service. The printer
does not operate when this message is displayed. The total number of pages
printed is also indicated, e.g. 0123456.
The corresponding paper cassette is not installed. Install the cassette. The
cassette number can be 1 (topmost) to 4 (bottom) [FS-2000D: 1 and 2].
This message warns following two cases. Install the new waste toner box.
The waste toner box is not installed.
The waste toner box is full.
Please clean the inside of the printer. Refer to Cleaning the Printer on page 3-8.
This message will be displayed when replacing the toner container after the
message Replace toner is displayed. After cleaning the inside of the printer,
press [GO] and the printer will be ready for printing.
The left cover of the printer is open. Close the left cover.
The rear unit of the printer is open. Close the printer rear unit.
The top cover of the printer is open. Close the printer top cover.
You attempted to print with a paper size and paper type that cannot be used for
duplex printing. Press [GO] to print onto one-side of the paper only.
Corrective Action
Troubleshooting
4-5