Kodak 5500 User Manual page 86

8-12
11. Replace the imaging guide with the bar code attached to it.
NOTE: Refer to Chapter 5, Maintenance for procedures on
removing the imaging guides.
12. Swing the vertical transport plate closed and rotate the release
handle 180 counterclockwise (so the red arrow aligns with the red
rectangle) to latch the transport plate.
Red arrow
Red rectangle
13. Close the side access door.
14. Release and lower the horizontal transport plate back into its
original position.
15. Lower the release bar and latch the front scan module into its
original position.
16. Close the lower access door.
17. Close the upper access door.
When you have finished attaching the bar code to the imaging
guide, return to the status display and continue with the following
steps:
Put BC Doc Close
Door, Press Enter
A-61070 September 1999