eMachines etower Series User Manual page 48

.........................................................................................................................................
AC Power default status
This option specifies how the computer responds to a power failure or when you connect the AC
power cable to your computer. If you set it to Off, the computer keeps power off until power
button pressed. If you set it to On the computer restores power. The settings are Off and On.
Remote Power On LAN
If your computer has a PCI add-in network interface card (NIC) with remote wakeup capabilities,
this option specifies whether or not the computer responds to a LAN wakeup event through a
network when the power is off. The settings are Disabled and Enabled.
Remote Power On Modem
This option specifies whether or not the computer responds to an incoming call on an installed
modem when the power is off. The settings are Disabled and Enabled.
Suspend Time Out
The option specifies the length of the period of system inactivity for going into suspend mode.
When the specified period expires, the computer enters suspend mode, beeping twice. The
settings are Disabled, 4Min, 8Min, 12Min, 20Min, 40Min, and 60Min.
Parallel port
This option specifies if the computer is to monitor parallel port activity for power conservation
purpose. When this option is set to Monitor and there is no parallel port activity for the length of
time specified in the Suspend Time Out option, the computer enters a power saving state. The
settings are Ignore and Monitor.
Floppy disk
This option specifies if the computer is to monitor floppy disk activity for power conservation
purpose. When this option is set to Monitor and there is no floppy disk activity for the length of
time specified in the Suspend Time Out option, the computer enters a power saving state. The
settings are Ignore and Monitor.
......................................................................................................................................................................................................................................
Using the BIOS Setup Program
4-11