Basic remote control operations for other components
Storing the remote control code of the other
The remote control unit can store the remote control code of the other
components and you can operate the other components from the remote
control unit. The remote control code is stored on the key or memory of
the remote control unit.
Storing on the key
You can store the remote control code to the key as shown below:
Point the infrared ray system part of another remote control
unit to the remote sensor of the remote control unit.
1 (Fast forward)
DSP MODE DOLBY VIRTUAL
unit of the other
Infrared ray system part
Press and hold the LEARN key for 3 seconds until
twice, then release the Learn key.
Press the Numeric key to enter 9 , 7 , 5 .
Press any of the Source keys (DVD/6CH, VIDEO 1, VIDEO 2,
VIDEO 3, CD/DVD, PHONO, AV AUX, MD/TAPE, TV MODE) to
select the input of the desired remote control unit.
• While in Tuner mode, learning code function is not available.
Press the desired key of the remote control unit.
• "LEARN" and
appear on the display.
From the remote control unit of the other source, press the key
that you want to store.
• The remote control code is sent to the remote control unit.
• "OK" appears when finished.
• If the code cannot be stored after a few attempts, "ERROR" will
appear. Repeat from step 2 onwards.
The remote control code is stored on the key of this remote
Repeat step 4 to 6 to store additional components until all
the desired components are stored.
To exit the learning mode, press and hold the LEARN key for
3 seconds until
To clear the stored remote control code of the other sources:
1 Press and hold the LEARN key for 3 seconds until
twice, then release the LEARN key.
2 Press the Numeric key to enter
3 Press the Source key, then press the stored key twice until
blinks twice to indicate that the stored remote control code are
9 , 7 , 6 .