Presetting Disc Names (Dnps) - Kenwood KDC KDC-V6017 Instruction Manual

CD/External disc control features

Presetting Disc Names (DNPS)

Store the names of discs to be displayed when played.
1
Play the disc whose name you want to preset.
NOTE
• This function is not available for disc changers that do not
feature the Disc Name Preset function.
• The Disc Name Preset function cannot be used during the
Magazine random play as well as while a disc title or track title
is displayed.
2
Press the NAME.S button for at least two seconds.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
Press either the 4 or ¢ button to move the cursor to the
3
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the 4
or ¢ buttons, respectively, on the remote.
Each press of the 38 button results in the type of characters
4
that are to be entered changing between alphabet and
numerals/symbols.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ " ' ` % &
Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê
ë î ï ô ö û ü ñ ç © Æ › fi
NOTE
Direct Alphabet Input
(Function of remote with number/letter entry buttons)
If the disc changers that were manufactured and sold after 1997
(except for KDC-C560) are connected, you can directly input
letters using the number/letter entry buttons on the remote.
Example: Use the following table to enter the name "DANCE".
Character
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
NOTE
You can enter up to 12 characters for each name.
6
Press either the NAME.S button on the main unit or the OK
button on the remote.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
NOTE
• The number of discs whose names can be stored will differ
depending on the disc changer that is connected. Please see
your disc changer manual for details.
Up to 30 CDs can be registered with this unit.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
∗ + - = , . / \ < > [ ]
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button erases the disc names stored in this
unit, but does not erase the names stored in a disc changer.
— 24 —
Button to press
#3
"D"
#2
"A"
#6
"N"
#2
"C"
#3
"E"
# Times pressed
1
1
2
3
2