Theft Deterrent Faceplate - Kenwood KDC KDC-V6017 Instruction Manual

General features

Theft Deterrent Faceplate

The faceplate can be reversed to hide the control panel or
detached form the unit, helping to deter theft.
Removing the Faceplate:
1
• When the control panel is visible:
Press the release button.
• When the control panel has been hidden:
Press the upper side of the faceplate.
2
Holding the center part of the faceplate, pull it out.
3
Push back the bottom of the faceplate bracket until it locks.
2CAUTION
• Do not apply excessive force to the faceplate bracket without
attaching the faceplate. Doing so will cause the faceplate
bracket to be deformed.
• Do not touch the connector on the faceplate bracket after
removing the faceplate. Touching the connector may cause
damage to the unit.
NOTE
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the faceplate
in its special storage case while detached.
• Do not expose the faceplate or its storage case to direct
sunlight or excessive heat or humidity. Also avoid places with
too much dust or the possibility of water splashing.
Reattaching the Faceplate:
1
Hold the faceplate so that the control panel faces the front
toward you and set the left side of the faceplate in the
faceplate bracket.
2CAUTION
Do not set the right side of the faceplate in the faceplate bracket
first, when reattaching the faceplate. Doing so may cause the
connector on the faceplate bracket to malfunction.
2
Press the right side of the faceplate until it locks.
Hiding the control panel:
1
Press the release button and slide open the faceplate.
2
Push upward the back of the control panel and reverse the
panel.
NOTE
The panel cannot be reversed when the faceplate is not attached.
Opening the control panel:
1
Press the upper side of the faceplate.
The faceplate will open.
2
Push the bottom of the control panel and close the faceplate.
— 10 —