Installation (Japanese-Cars) - Kenwood KDC-715S Instruction Manual

Cd receiver
Hide thumbs Also See for KDC-715S:
Table of Contents

Advertisement

Installation (Japanese-cars)

I
Installing Radio Bracket in Japanese-made Cars (J-Cars)
On the factory-installed radio bracket, flatten all
the tabs or holes that are not flush (except
those used for screws), using a hammer or
similar utensil.
Tab
Hole
Factory-installed
Radio Bracket
Factory trim bezel
Accessory8
J-Car Bracket
(follow indications for L/R)
N
T
L
T
N
Accessory9
J-Car Trim Plate
(place thick part on
bottom)
Factory-installed
Radio Bracket
N
T
R
T
N
Once you have affixed the factory-installed radio bracket
with the screws, use a standard-tipped screwdriver (not
Philips) or similar utensil to pry the tabs of the J-Car
bracket to make them fit into the holes in the factory-
installed radio bracket (depending on the car make).
— 45 —
After aligning the J-Car bracket
with the factory-installed radio
bracket, tighten the screws.
8mm
8mm
5mm
5mm
Accessory5
Accessory6
for Nissan car
for Toyota car
2CAUTION
Damage to the unit will result
from using screws other than
those provided.
Tab
N ... Nissan car
T ... Toyota car

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

8015Kdc-8015Kdc-x715

Table of Contents