JVC VN-V25U VN-V26U Instructions Manual page 31

6.
The top page of VN-V25U/26U appears
7.
The [Basic] page with the IP address settings appears when DHCP is not in use
A confirmation screen appears. Press the [OK] button. VN-V25U/26U restarts using the new IP
address. It takes about one minute for the camera to reboot.
Note:
● Access from this computer may fail when the IP address of VN-V25U/26U is changed. To enable
access to VN-V25U/26U from the same computer, alter the IP address at the computer accordingly.
When the display or configuration of the opened screen appears strange, check
using the following procedures.
A
[Start] - [Control Panel]
Click
B
[Settings]
Click the
C
[DPI setting]
Check that
D
Otherwise, change the setting to
- [Display]
and open the
[Display Properties]
tab in the
[General]
in the tab has become
[Normal size(96DPI)]
Click on [Network], followed by [Basic]
on the next submenu.
A
Set the [IP Setting] item to [DHCP
Disable].
B
Enter the values you wish to specify in
the [IP Address], [Subnet Mask] and
[Default Gateway] fields.
Click [OK].
C
[Display Properties]
[Advanced]
windows and click the
[Normal size(96DPI)]
andreboot windows
window
button
31