Download Print this page

Connecting The Converter Box; Disconnecting The Existing Digital Signal Cable; Fig. 3 Converter Signal Cable (Length 65Cm Approx.); Fig. 4 User's Guide (This Book) - IBM 07N2229 User Manual

Converter box for the t221 flat panel monitor
Hide thumbs


P/N: 07N2229

Fig. 3 Converter signal cable (length 65cm approx.)

P/N: 55P5729

Fig. 5 Dual Link signal cable (length 200cm approx.)

Do not use other cables for T221 and the converter box.
Do not use these cables for other equipment than the T221 monitor and converter box.

2. Connecting the Converter Box

See your monitor manual for instructions and precautions on handling the monitor.
Use a large desk or table covered with a soft, thick cloth if you need to lay the
monitor face down during installation. Make sure there are no pencils, clips, or other
hard objects under the monitor screen, and avoid knocking or bumping the monitor.
Such treatment could damage the monitor.
2.1. Disconnecting the Ex isting Digital Signal Cable
Power off both of the monitor and the computer.
Unplug the AC power cords of the monitor and computer from the wall outlets.
At the back of the monitor, remove the stand rear cover and connector cover, and disconnect the

Fig. 4 User's guide (this book)

P/N: 55P5776



This manual is also suitable for:

07n223013m320055p5728T t22155p572955p5776