Diagnostic Program - Casio PX-130 Service Manual & Parts Manual

Initial Setting
1. Connect the AC adaptor.
2. Connect the pedal.
Even if a pedal unit is unavailable for the test, all the tests except for the pedal check may be performed.
* SP-3 is the pedal unit that comes with PX-130.
Connect it to the DAMPER PEDAL terminal in the back of the main unit.
* SP-32 is a pedal unit sold separately.
Connect it to the pedal connector on the bottom of the main unit.
To use SP-32, you will need the stand CS-67P, sold separately.
3. "Main" volume: MAX
4. Have a PC and a USB cable ready. (They will be used in the USB check.)
Operating System:
How to start the diagnostic program
1. Hold down the "METRONOME", "RECORDER", and "SONG (u/n)" buttons at the same time, to turn
the power ON.
2. Release the "METRONOME", "RECORDER", and "SONG (u/n)" buttons.
3. After the diagnostic program is launched, Automatic Test will start.
Select Sequential Test or Single Test after Automatic Test is completed.
Be sure to turn off the power when the test is finished.
Test Items
This diagnostic program tests the following items.
Selecting the "2. Model check" will run Test 2 (Model check) through 8 (Key check) in sequence.
The "9. Flash Memory check" is a single test. (see page 37)
No.
1 Automatic Test
2 Model check
3 ROM Version check
4 Button check
5 Pedal check
6 Headphones check
7 USB check
8 Key check
9 Flash Memory check

DIAGNOSTIC PROGRAM

®
Windows XP (SP2 or later) *1
®
Windows Vista *2
®
Windows 7 *3
®
Mac OS X (10.3.9, 10.4.11 or later, 10.5.6 or later,
*1: Windows XP Home Edition/Windows XP Professional (32 bit)
*2: Windows Vista (32 bit)
*3: Windows 7 (32 bit, 64 bit)
Test Items
Sequential Test
Single test
– 32 –
RAM, ROM, LED
(Performed at the launch of the diagnostic program)
Internal, External
Pedal
Headphones
PC, USB cable
10.6.2 or later)
Note