Operation; A) Switching The Devices On And Off; B) Measuring Methods - VOLTCRAFT LSG-10 Operating Instructions Manual

8. Operation

a) Switching the devices on and off

Press the power button (10 or 16) to switch on the devices.
To switch the devices off, hold down the power button (10 or 16) for about 2 seconds.
Note: Before working with the cable detector, insert the enclosed batteries.

b) Measuring methods

The cable detector can be operated in three different modes. The receiver has a visual and an audible indicator in
all modes.
• Automatic Mode
Automatic mode facilitates fast cable detection. No settings need to be configured. The receiver automatically sets
the sensitivity to achieve the best measuring results.
• Manual Mode
Manual mode is ideal for selecting cables or performing measurements at a higher sensitivity. The sensitivity must
be set manually.
Press "MODE" to switch to manual mode. "SENSE" will be displayed.
The arrows (6 and 9) are used to set sensitivity. The arches displayed correspond to the sensitivity (few arcs = high
sensitivity, many arches = low sensitivity).
Pressing the "MODE" button again will take you back to automatic mode.
36