Download Table of Contents Print this page

Assembly; Fitting The Loop Handle; Assembling And Dismantling The Two- -Piece Shaft; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 125LDx Operator's Manual

Husqvarna hedge trimmer operator's manual

Advertisement

Table of Contents
NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.

Fitting the loop handle

S Position the handle on the upper shaft
leaning towards the engine. Note that the
handle must be mounted between the
two arrows on the shaft.
S Fit the screw, securing plate and wing
nut as shown in the diagram.
S Tighten the wing nut.
Assembling and dismantling
the two- -piece shaft

Assembly:

S Loosen the coupling by turning the knob.
S Align the tab of the attachment (A) with
the arrow on the coupling (B).
B
S Push the attachment into the coupling until
the attachment snaps into place.
S Before using the unit, tighten the knob se-
curely.
ASSEMBLY
Dismantling:
S Loosen the coupling by turning the knob
(at least three times).
S Push and hold the button (C). While
securely holding the engine end, pull the
attachment straight out of the coupling.
itting the trimmer guard and
F
trimmer head
S Fit the correct trimmer guard (D) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting
on the shaft and secure with the bolt (E).
A
D
S Fit the drive disc (F) on the output shaft.
S Turn the shaft until one of the holes in the
drive disc aligns with the corresponding
hole in the gear housing.
S Insert hex wrench (G) in the hole to lock
the shaft.
S Screw on the trimmer head (H) in the op-
posite direction to the direction of rota-
tion.
S To dismantle, follow the instructions in
the reverse order.
9
C
E
D
H
F
G

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

125c125l

Table of Contents