Table Of Contents; Introduction - Husqvarna 125B Operator's Manual

Contents

Introduction

. . . . . . . . . . . . . . . . . . .
Key To Symbols . . . . . . . . . . . . . . . . . .
Safety Instructions . . . . . . . . . . . . . . .
Description . . . . . . . . . . . . . . . . . . . . .
Fuel Handling . . . . . . . . . . . . . . . . . . . .
Starting And Stopping . . . . . . . . . . . .
Using The Blower . . . . . . . . . . . . . . . . .
Maintenance . . . . . . . . . . . . . . . . . . . .
Technical Data . . . . . . . . . . . . . . . . . . .
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any nonroad engine re-
pair establishment or individual.
Note the following before
starting:
Husqvarna AB has a policy of continuous
product development and therefore
reserves the right to modify the design and
appearance of products without prior
notice. Long- -term exposure to noise can
result in permanent hearing impairment.
Always use approved hearing protection.
This operator's manual describes in detail
how to use and service the blower and
how to carry out regular maintenance. It
also describes which measures should be
taken to achieve maximum safety while
operating the blower, how the safety de-
vices work and how they should be ser-
viced.
Note! The section of the manual that deals
with safety, must be read and understood
by all persons who come in contact with
the blower.
This operator's manual has been written
for those who need guidance when it
comes to fault tracing, thorough servicing
and carrying out corrective maintenance of
the blower.
There are warning symbols on the blower.
Should any of the warning symbols on the
blower become disfigured or worn, new ones
should be ordered and fitted to the blower as
soon as possible. Note that some of the
warning symbols may be molded in certain
components of the blower.
545154658 Rev. 2 7/10/07
CONTENTS
The blower is used for blowing away leaves
and other debris on the ground. When op-
2
erating the blower, the operator must stand
with both feet firmly on the ground.
3
4
The Emissions Compliance Period referred
6
to on the Emissions Compliance label indi-
11
cates the number of operating hours for
which the engine has been shown to meet
12
Federal emissions requirements.
13
Category C = 50 hours, B= 125 hours, and
A = 300 hours.
16
19
For reference, please fill out the following
information that will be needed for future
servicing of your blower:
Model Number:
Serial Number:
Purchase Date:
Purchased From:
WARNING:
stances may the design of the
machine be modified without the
permission of the manufacturer.
Always use genuine accessories.
Non- - authorized modifications
and/or accessories can result
in serious personal injury or the
death of the operator or others.
Your warranty may not cover
damage or liability caused by the
use of non- - authorized accesso-
ries or replacement parts.
For customer assistance, call:
1-800-487-5951
Contact us at our website:
www.husqvarna.com
Under no circum-
English--- 2