Cutting Height Adjustment - Husqvarna WHF6123 / 966947007 Operator's Manual

Cutting Height Adjustment

WARNING!
Before performing any service or
adjustment checklist
• Make sure the blades and all
moving parts have completely
stopped.
• Turn the ignition switch to "OFF"
position and remove the key.
• Remove spark plug wire.
To change the deck cutting height - hook the deck
latch onto the latch pin on each side of the frame. Use
the height of cut decal to find the corresponding hole
for the desired height. Push the retainer pin into the
correct hole in the height rod.
IMPORTANT INFORMATION
To achieve the best quality cut, the blades
should be level with the ground or slightly
tipped forward.
oPERATIoN
Remove spark plug wires
1
1. Deck latch
2, latch pin
3. Retainer pin
4. Height rod
Height adjustment
2
4
Husqvarna-27
8062-024
3
8062-034