Download Print this page

Assembly - Husqvarna 115 145727 Operator And Parts Manual

Grass catcher 42"
Hide thumbs

Advertisement

1
INSTALL PLATE AND HANGER
1.
Using hardware provided in kit, attach support
mount to unit.
2.
Attach hanger bracket to support mount. Do not
fully tighten nuts at this time.
Support Mount
Hanger Bracket
3.
Secure rear end of support straps to outside of
hanger assembly. Set reinforcement plates to the
outside of the tank brackets and fasten front end
of support strap to tank bracket and reinforcment
plate with round head bolt. Secure front end
of reinforcement plate to tank bracket with hex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Depending on model, rear guard hole may
need to be drilled out to
large.
Hex Bolt Placement
Round Head
Bolt Placement
Support Straps
8

ASSEMBLY

/
" if kit hardware is too
5
16
Reinforcement Plate
2
MOUNTING COVER ASSEMBLY
TO SUPPORT ASSEMBLY
For ease of assembly, you may wish assistance from
another person for mounting the cover assembly to
mower.
1.
Position cover assembly on the ground behind the
mower.
2.
Lift and rotate cover to align the frame bracket
with the hanger and slide the cover down until
secure.
Frame Bracket
Hanger
3
INSTALLING SPACER PLUG
Remove plastic end cap from the center bag
support arm. Fully insert spacer plugs into the
ends of the support tube. It may be necessary
to tap the spacer into place with a hammer or
mallet. Replace the plastic end cap back over
the spacer. The additional extension will hold the
hood more securely when latched.
Insert spacer and
Remove center
replace cap
end cap
Cover Assembly

Advertisement

loading

  Related Manuals for Husqvarna 115 145727

This manual is also suitable for:

525 88 56-01966004001