Assembly - Husqvarna 128PS Operator's Manual

Hide thumbs Also See for 128PS:
Table of Contents

Advertisement

Available languages

Available languages

wear on the guide bar, saw chain and chain drive
sprocket increases.
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten.
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
10

Assembly

2. Move the locking/release button (A) into the
guide recess. Push the attachment into the
coupler until the locking/release button sets into
the primary hole (B).
3. Insert the shaft into the shaft coupling. The
button must go through the hole.
Note:
the upper shaft, use a small screwdriver to push
the internal drive shaft deeper into the tube. It
can be necessary to turn the screwdriver while
you push.
4. Make sure that you fully tighten the knob before
you operate the product.
To attach the pole saw attachment
WARNING:
level surface when you install or remove
the attachments.
If the attachment does not go fully into
Stop the product on a
1780 - 001 - 08.02.2022

Advertisement

Table of Contents
loading

Table of Contents