Download  Print this page

Advertisement

Press „ô, simultaneously if in RPN mode, to access to the PLOT
SETUP window.
Change
to
TYPE
Fast3D.
Press ˜ and type 'X^2+Y^2' @@@OK@@@.
Make sure that 'X' is selected as the
variables.
Press L@@@OK@@@ to return to normal calculator display.
Press „ò, simultaneously if in RPN mode, to access the PLOT
WINDOW screen.
Keep the default plot window ranges to read:
X-Left:-1
Y-Near:-1
Z-Low: -1
Step Indep: 10
Note: The Step Indep: and Depnd: values represent the number of
gridlines to be used in the plot. The larger these number, the slower it
is to produce the graph, although, the times utilized for graphic
generation are relatively fast. For the time being we'll keep the default
values of 10 and 8 for the Step data.
Press @ERASE @DRAW to draw the three-dimensional surface.
wireframe picture of the surface with the reference coordinate system
shown at the lower left corner of the screen. By using the arrow keys
(š™—˜) you can change the orientation of the surface.
orientation of the reference coordinate system will change accordingly.
Try changing the surface orientation on your own.
show a couple of views of the graph:
( @CHOOS!, find Fast3D, @@OK@@).
and 'Y' as the
Indep:
X-Right:1
Y-Far: 1
Z-High: 1
Depnd: 8
Depnd:
The result is a
The
The following figures
Page 10-6

Advertisement

Table of Contents

   Related Manuals for HP 48gII

Comments to this Manuals

Symbols: 0
Latest comments: