Download Print this page

Hoover Windtunnel UH70120 Owner's Manual: Filters; To Clean Hepa Filter

Hoover windtunnel series vacuum cleaner operating and servicing instructions.
Hide thumbs

Advertisement

dirt Cup
(continued)
how to empty
4.3 Press dirt cup
release button (A) and
pivot cup out.
4.4 Hold dirt cup over
trash receptacle, push
dirt cup door release
lever (A) to open dirt
cup door (B).
Close dirt cup door (B).
Press firmly to secure
at front (C).
4.5 Place bottom of dirt cup into vacuum body first. Pivot dirt cup into vacuum
body and press firmly until it locks into place.

filters:

when to Clean
To maintain optimal performance, filters should be
cleaned every two months under normal use.
rinsable filter: how to Clean
Remove dirt cup as described in Fig. 4.3.
4.6 Pull up on dirt cup latch (A) to open.
4.7 Pull on filter tab to remove Rinsable Filter.
Hold filter under running water for two minutes to
remove dirt and debris. Squeeze filter twice while
underwater. Squeeze a final time to remove
excess water.
IMPORTANT
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
Replace filter, tab side out.
Close lid securely by pushing at (B) until it clicks as
shown in Fig. 4.6.
Replace dirt cup as described in Fig 4.5.
hepa filter: how to Clean
4.8 With fingers in slots, pull filter frame (A)
straight out. Hold filter over a trash receptacle
and tap out dirt and debris.
Slide back into position on vacuum.
DO NOT RINSE OR WASH the HEPA Filter cartridge.
hepa filter: what to buy
When used and maintained properly, your HEPA Filter should never need
replacement. If desired, replacement filter is available. Ask for Hoover
no.303172001.
4.3
IMPORTANT
4.4
A
A
C
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
4.6
b
rinsable filter: what to buy
When used and maintained properly, your Rinsable
Filter should never need replacement. If desired,
replacement filter is available. Ask for Hoover
Part no.303173001.
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
9
4.5
b
CAUTION
4.7
A
CAUTION
4.8
A
Part
®
!
®
!

Advertisement

Table Of Contents

   Related Manuals for Hoover Windtunnel UH70120

This manual also for:

Windtunnel t series

Comments to this Manuals

Symbols: 0
Latest comments:
  • jamie holcombe Aug 27, 2018 07:19:
    my vacuum is about two years old I bought it from target it has
    been great but as I was vacuuming my moms room it got hot
    and quit working . I emptied the canaster turned it upside down
    to see if anything was caught in the rollers and it was not.
    it came back on in about 30min but its not sucking anything up.
    I ordered a filter it still does not work and ordered a belt but have
    not found anyone in oxford to put the belt on . Help
  • Jim Oct 03, 2017 12:53:
    UH70402 makes sputtering noise at the exhaust port
  • #unknown Aug 07, 2016 05:04:
    Vacuum gets hot quit running after cooling it runs for awhile
  • #unknown Aug 07, 2016 05:35:
    Vacuum gets hot and motor quit running after cooling off it runs for a while and repeat the process
  • nancy spruth Aug 05, 2016 10:09:
    How can I fix the whinning every time i start it. (its quite loud)