Table of Contents
Advertisement
SAFETY PRECAUTIONS (continued)
Floor Stand Setup
1
Remove the Stand Base from the Monitor
Keep the screws. They will
CAUTION
be used for the Floor stand
installation.
Install the Monitor on the Floor Stand
2
For Stand Assembly; please refer to the Installation Manual of the Floor Stand AS-LSZ0081 or AS-LSZ0082.
3
Attach the Monitor to the Floor Stand with the 4 screws used with the
tabletop stand.
Adjust Monitor position left or
CAUTION
right to match with screw holes.
If the screw holes do not align,
the Monitor may be damaged.
Please make sure screws
WARNING
are tightened properly.
UT32V502 and UT32V502W LCD UT Monitors are only for use with the Hitachi AS-LSZ0081 and
CAUTION
AS-LSZ0082 Floor stands respectively. Use with other floor stands could cause instability and
possible injury.
Remove the 4 screws and raise straight up from tabletop stand.
Monitor
About the Installation
This product is heavy and should be carried
by at least 2 people.
Screws from the
tabletop stand.
12
Advertisement
Table of Contents
