Remote Control Of The Tv - Hitachi DV-PF73U Instruction Manual

H9451UD(EN).qx33 03.1.22 7:22 PM
PROGRAMMING THE REMOTE
CONTROL FOR THE TV
1
Turn off the TV.
2
Program the remote control
Aim the DVD/VCR's remote control at your TV set.
Hold down the TV POWER button while you press
the number corresponding to your brand of television
as shown in the chart.
For example; If you have a Hitachi television, press
the TV POWER and 1 at the same time. If this but-
ton combination sends a signal that matches with
your TV, the TV will turn on, and you'll know the
remote is set to control the television.
NOTES:
¡ If that button combination does not change the TV
channel, go through the whole list of button combi-
nations one by one until you find one that does
change your TV channel.
¡ Also, if your brand of TV is not listed in the chart,
try all the number buttons. One of them may work
for you.
If the TV channel still doesn't change after going
¡
through all the button combinations listed, it is like-
ly that you will not be able to program this remote
control for your TV.
TV Brands
HITACHI
SONY
RCA
SANYO
ZENITH
PANASONIC1
PANASONIC2
SHARP1
SHARP2
TOSHIBA
JVC
MITUBISHI
MAGNAVOX
FUNAI
GOLDSTAR
Page 16

REMOTE CONTROL OF THE TV

Press the TV and This Number
1
2
3
4
5
6
7
8
9
0
CLEAR
+10
SUBTITLE
AUDIO
DISPLAY
CONTROLLING THE TV
Once programmed, the DVD/VCR's remote control is
ready to control the TV.
NOTE: Be aware that not all of your TV's functions
may work even though the remote control is
correctly programmed.
To operate the TV
You can turn on your TV by pressing the TV
¡
POWER button.
You can change the channels with the TV CH
¡
(o/p) and the volumes with VOL (o/p) .
To operate the DVD/VCR
Press the VIDEO/TV to operate your DVD/VCR with
the remote.
NOTE: VIDEO/TV button is not corresponded to
TV which can switch to TV input mode
directly.
– 16 – – 16 – EN EN
2C05 1L25