Operation of this equipment
may create sparks that
can start fires around dry
vegetation.
A spark arrestor may be
required.
The operator should contact
local fire agencies for laws
or regulations relating to fire
prevention requirements.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Note: See Mounting Base Layout Diagram
and Engine Shaft Layout Diagram on
page 10.
1.
The tapered Crankshaft (55) is 5/8”
at its thickest diameter. Therefore,
the Belt Pulley or Sprocket Pulley
(neither included) attached to the
Crankshaft must have a 5/8” inside
diameter. The Belt/Sprocket Pul-
ley and Belt/Chain used must have
proper guards (not included) attached
for safety purposes.
2.
Make sure to mount the Engine on a
sturdy equipment surface capable of
supporting the weight of the Engine
and the equipment itself.
3.
The equipment to which the Engine
will be attached must have matching
bolt hole patterns and be attached
using the proper size bolts (not in-
cluded).
OPERATING INSTRucTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under